Painel de Comentários

  • Brennan199
    Proprietário do Concurso
    • 7 meses atrás

    I can print threads in plastic but I'd think embedded SAE nuts and bolts will be much stronger (the winning design will have thought of this as well as what it's clamping to for best fitment). The lower portion will be very weak if printed in plastic (again, to work it should have a captured or pressed in nut). In my sketch I made the sliding part of the vice as 2 parts with a captured nut. This negated the need for a back to the vice and extra stability at the sides as it was fully supported in a bottom groove.

    • 7 meses atrás
  • macene16
    macene16
    • 7 meses atrás

    please check kindly and let me know your comments.
    So we can go and back forward for completion.
    Regards

    • 7 meses atrás