This are my requirements.
1.- Know if this board can power on, I mean, if the Processor (MPU), the Flash Memory, RAM, etc is connected right.
If I power it with 5 VDC I will be able to install linux on it and will have access to the board using an Ethernet Cable.
2.- Find a good, cost-effective LCD that works with this board. Find all the Components that would be available on Digikey, Mouser, Jameco. In other Words, I need the BOM with Digikey/Mouser/Jameco part numbers. If an IC/resistor,Capacitor is not on Digikey/Mouser/Jameco, replace it with a cross and update the Schematics if necessary.
At the end, I will have a fully operational PCB, without any errors, and a well documented BOM with part numbers that will be easily accesible on Digikey/Jameco/Mouser. An Also a corresponding cost-effective LCD also with part number of Digikey/Jameco/Mouser
I need the Full Altium Designer project design files to check the work pior release the final milestone.
Hi I am experienced electronics engineer with more than 8 years of experience. I can do it for you. I have completed more than 8 years of experience. Please get in touch to get started Regards