Live HFSS Microwave Network Workshop

I’m looking for someone who can prepare a pre-recorded, step-by-step walkthrough with screen recording and voice explanation for my Microwave Engineering course project, which is based on ANSYS HFSS and ANSYS Twin Builder. I do not need a live session. I want a clear recorded video that I can watch later and use as a reference while building and documenting my own project. My project is “Design and System-Level Integration of Antenna Microwave Feeding Network”. The main idea is to design a microstrip-based RF front-end / feeding network for antenna integration, starting from hand calculations, then building the physical EM models in HFSS, optimizing them, and finally exporting the HFSS blocks into Twin Builder for full system-level validation. The project requires realistic microwave design practice, electromagnetic modeling, system integration, and performance evaluation using HFSS and Twin Builder. The project includes multiple required components, not just one simple line. The tasks include: Microstrip transmission line design Unequal T-junction power divider with 3:1 ratio Unequal Wilkinson power divider with P3/P2=1/3 P 3 ​ /P 2 ​ =1/3 Four-way corporate power divider using Wilkinson stages Branchline coupler Single-section directional coupler Microstrip filter Four-way divider with 45-degree progressive phase Microstrip resonator Rectangular cavity resonator Three-port circulator Final system-level integration in Twin Builder using exported HFSS S-parameter blocks What I need from you in the video: Start from the hand calculations using standard microwave design equations. This should include, where relevant: characteristic impedance effective dielectric constant guided wavelength microstrip width and length quarter-wave sections coupling dimensions / resonator lengths / resistor values / phase-delay lines, depending on the chosen example Show how to convert the calculations into a full HFSS model step by step: variable setup substrate and conductor creation geometry drawing material assignment port definition boundaries solution setup sweep setup validation simulation result extraction Explain why each HFSS setting is chosen, not only what to click, so I can later defend the design process in my report and presentation. Show how to read the main plots properly, especially: S11 S 11 ​ insertion loss / transmission coefficients isolation coupling phase difference, if relevant resonance behavior, if relevant If possible, also show a brief example of how the HFSS result can be used later in Twin Builder for system-level validation, since my project requires HFSS-to-Twin Builder integration. Written material I need with the video: Please also provide a short written technical note or mini-report that includes: the chosen design example and design goal assumptions and substrate/material parameters main formulas used hand-calculation summary parameter table with dimensions key HFSS setup choices what was tuned and why how to interpret the final plots a short conclusion on whether the design met the target Important project requirement: My course project requires that each component starts from hand-calculated initial values, then is built physically in HFSS, then optimized in AEDT/HFSS, and later integrated at the system level in Twin Builder. It also requires a technical report, HFSS project files, Twin Builder integration, and a presentation. So I need the explanation to be at a student project / report / viva level, not just a fast tutorial.

ID do Projeto: 40319048