Em Andamento

Arch display

Hello Again

OK here is the next project. I would like you to please model and render this new display. It is basically a white arch with a 16mm black matte panel framed in the middle. It is a freestanding display and is double sided. I have attached a sketch. Side 1 is shown in the sketch. The other side is identical except that instead of the Cascade boxes it has the Pegasi boxes and instead of the Chisel boxes it has a tall white flat box 2350 x 550 x 75 on which we will display the tall showers. (no brochure or decals on that box)

On the left side you will see it has a big Faucet Strommen Logo. 500mm wide placed at 200mm from the top. Below that are the 2 round logos as per previous project, but 200mm diameter.

On the other end there are 3 large pictures. Starting from the top picture d, c then b at 500 square with radius 10mm corners.

There are 2 downlights under each side of the "ceiling" centered 75mm from the front

Please model and render this in the same setting at the "cube display" that you did recently. i.e. wood floor, same showroom etc. perhaps a few views showing different sides etc would be great.

I am in a bit of a rush for this as well. Just do what you can, no great pressure.

Thanks a lot

Habilidades: Modelagem 3D, Renderização 3D

Ver mais: model logos, logo render, front rush, floor render, 3 d render, wood logo, render square, black wood, arch, showroom logo, model sketch, showroom render, display cube, display model, project showroom, front side sketch, box display, white brochure, black square logo, logos boxes, floor display, logo front brochure, black square logos, matte, display pictures

Acerca do Empregador:
( 114 comentários ) Kerang, Australia

ID do Projeto: #5149663

Premiar a:

Raluca27

Hired by the Employer

$80 AUD em 2 dias
(15 Avaliações)
3.7