Em Andamento

Modify Marlin firmware to support 6 axis -- 2

I need you to edit Marlin firmware to make it support 6 stepper motors as 6 axis (X, Y, Z, A, B, C) and 6 endstops for that axis.

Now, Marlin supports 3 axis (X, Y, Z) and 3 extruders (E0, E1, E2).

We have Megatronics 3.0 board which has 6 stepper drivers and 6 endstops.

Now, E0, E1 and E2 can be controlled, but not as main axis, they don't have endstops and theirs options like feed rate (and others) cannot be set up separately.

The best would be if you would set up git repository, fork official Marlin firmware there and make changes which we can test and approve.

I'm here if you need more information.

Habilidades: Arduino

Ver mais: x-axis, stepper, firmware, arduino controlled, stepper drivers, E1, modify feed php, rate modify, modify fork, modify rss feed module joomla, dg834 modify firmware, edit modify rss feed web page, php modify rss feed, accpac technical support hourly rate, modify rss feed xml, internet explorer doesnt support feed, software support hourly rate, ongoing website support rate

Acerca do Empregador:
( 7 comentários ) Zagreb, Croatia

ID do Projeto: #6839175

2 freelancers estão ofertando em média $189 para este trabalho

anatolyzimin

Hello! I think, I can help you, I have wide experience in Arduino and Embedded C. I don't have required shield, but ther's not a problem, I think. You're welcome and thanks for your time!

$177 USD in 3 dias
(0 Comentários)
0.0
jyoung6

Hi, Check out my linkedin profile: I have experience with building and coding 3D printers, so Im familiar with the software and hardware aspects of the design. I can knock this project out in about a week with you Mais

$200 USD in 7 dias
(0 Comentários)
0.0