I have three DXF files that need to be redesigned. Each file contains a single gear like object. Modifications required will be increasing the diameter of each object from 8.75" to 10.75", recalculating and respacing the 2" deep slots that are around the rim for uniform distribution and minimal spacing between slots. Slot width at outer is edge is uniform for each disk. Each disk will have only size slot machined into them. I.e. disk 1 @ .5", disk 2 @ .75" and disk 3 @ 1.0" Minimum spacing limit between slots is ~3/16". Lastly increasing the center hole in each disk to 2.005". Files are included. Disks will be cut with a waterjet.
29 freelancers are bidding on average $106 for this job
Hello dear, I am a M.Sc. Engineer. I am expert in drafting and designs using Autocad so I can help you for sure in your task and I will finish it in the required time. Please check my portfolio and reviews. Thanks.
Hello, my name is Anton, I am an architect, I have more than 6 years of experience in Revit and autocad, I am ready to start working and hope for cooperation, thank you