Write efficient C software for an existing Microchip dsPIC application. This project is about writing the drivers largely and demonstrating that the drivers are fully functional by writing a small test application. Also required is development of IR/RF communication software between a Raspberry PI system with a CC1101 module and a Vishay TSAL6100 infrared transmitter and the PIC based system.
There are two milestones for this project:
MILESTONE 1 – SATR DRIVERS ON CURRENT HARDWARE
60% of the successful bid for achieving this milestone. Includes test application complete except for Raspberry PI integration.
MILESTONE 2 – RASPERRY PI DRIVERS AND INTEGRATION.
40% of the successful bid.
Each milestone being delivery of fully functioning drivers with test application working to my satisfaction along with fully commented source code. The freelancer is expect to provide me after completion of the project free question and answer support in relation to these drivers.
The freelancer must have deep experience with dsPIC programming with low level drivers. The freelancer should have experience with infrared communications and the CC1101 radio module from TI.
See attached documentation for further details on the project. Note that all software developed for this project will belong to Pathfinder Events Pty Ltd.
Drivers should be completed with 3 weeks of the freelancer receiving the development hardware from me. Hardware will be sent to freelancer by tracked courier service. Freelancer must send back at freelancers cost all hardware supplied also by tracked courier service when the project ends so factor that cost into the bid. Work should be able to start however before hardware is delivered.
13 freelancers estão ofertando em média $1156 para esse trabalho
Hi, I have expertise in working with CC1101 and PIC Controller. I have understood your requirements and I can execute it in less possible time. Looking Forward,
Hi, I am shiv having an experience from 1 to 12 years in developmet. I have my 2 Raspberry Pi devices. I would be very happy to assist you on this project. Looking forward to your response. Best Regards.
Hello, I am expertise in dsPIC mcu firmware programming with spi,i2c,gpio,usb protocol.I can develop the driver for the mcu [login to view URL] details we can discuss through chat. Regards, Nimain