Redesign of a WiFi board which was designed in Altium designer. The new design should be in Eagle. There will be several minor changes to the PCB and BOM. The PCB is a small, one sided PCB (24x18mm) that includes:
WiFi SoC + Flash
Atmel SAM MCU
Antenna (impedance control)
The board is based on a hardware development kit (HDK) design. The redesign should be according to this HDK.
Change / check Shematic based on the HDK
BOM including suppliers
Good knowledge in PCB design and manufacturing
Good knowledge about Microcontroller and Flash devices
The whole project is strictly confident. The Freelancer has to sign a NDA before start.
The Freelancer will get further information if necessary.
35 freelancers are bidding on average $546 for this job
Hello, I have experience of designing PCBs in Eagle. I would like to be considered for your job. I have done work before, and I can show you samples of my work if you want. waiting to hear from you. Thanks
I have many years experience in various kinds of PCB layout, have Altium layout translated to Eagle experience, I can use Eagle 7.1 or 6.5 to do the layout.