Encerrado

Brushless DC Generator using car generator - open to bidding

The project is to design a prime mover to drive the generator and make it work. This prime mover should be consist of stator coils and permanent magnets rotor that is connected with the generator in the same shaft. In order to start the generator the coils of the prime mover should be excited by a current supplied using a PCB controller circuit that controls the speed of the generator and the amount of current supplied to the prime mover.

the out put voltage should be stored in a 12 V DC battery.

Habilidades: Engenharia Elétrica

Ver mais: prime design, dc design, electrical project work, Electrical CIRCUIT, dc, dc to dc, dc dc, dc current, current voltage, brushless, order controller, speed pcb, drive generator, pcb design car, pcb design bidding, engineering project bidding, design speed controller, battery circuit, battery pcb design, controller pcb

Acerca do Empregador:
( 0 comentários ) Malaysia

ID do Projeto: #6844103

5 freelancers are bidding on average $603 for this job

bchandra1955

Professional engineer here , I can take care of this project in 3 days time....................................Pls offer work with 50% MILESTONE

$757 USD in 21 dias
(27 Comentários)
5.0
seshupower

Hi, I am a post graduate power electronics engineer and having excellent industrial experience in product design and development. I am very good in brush less DC generator design and control circuit. I have good exper Mais

$750 USD in 20 dias
(12 Comentários)
4.7
DamithaKD

HI, About ME : I am a programmer for 8 years and has perfect reviews on all my projects. I am a Expert in Delphi and Scjp, I have a Diploma in Electronics and [url removed, login to view] in Electrical and Electronic Engineering ( NIT Mais

$555 USD in 10 dias
(11 Comentários)
4.4
faizankhalid89

the controller assembly and the PCB and other current specifications can be met once i'm hired for this project to complete tit, as I am an electrical engineer.

$555 USD in 10 dias
(0 Comentários)
0.0
bukachIB

Hi, the problem looks is not difficult. If we understand correctly, we need to 12v battery connected to a Brushless motor that is attached to the shaft through the car generator. Get some output voltage and power. Mais

$400 USD in 10 dias
(0 Comentários)
0.0