Cancelado

3d printer pcb layout -- 2

rpi a+ board piggybacked on a board that controls 7 tiny stepper motors (2 different types), a laser, a fan, temperature, and 2 galvanometers via dsp.

a layout exists, but that´s not good enough, but you can see the scope there, however i want to avoid the st32f4 and use the rpi a+ board instead. you would also need to write the firmware.

no upfront payment until I see a working layout, I already lost time and money...

Habilidades: Engenharia Elétrica, Eletrônica, Software Integrado, Microcontrolador, Layout PCB

Veja mais: 3d via, stepper, see ELECTRICAL, rpi, printer firmware, pcb layout, pcb board, electrical layout, board layout , write electrical engineering, electronics firmware, pcb firmware, dsp pcb, fan temperature, layout pcb design, schematic preampl tube layout pcb, pcb beagleboard d, ampli tube layout pcb, board layout pcb tube amp, layout pcb tube

Acerca do Empregador:
( 1 comentário ) neuss, France

ID do Projeto: #6940197

2 freelancers estão ofertando em média $7500 nesse trabalho

theenggprojects

Hi, I am a Mechatronics and Control Engineer, you cna check my work on my blog [login to view URL] , I am expert in embedded and can design this complete project. I will give you complete progress of project Mais

$10000 USD in 45 dias
(37 Comentários)
6.5
eephd

I have BS, MS and PhD degrees in Electrical and Electronics Engineering from one of the most reputable universities in Turkey and have 15 years of analog and microcontroller based systems design experience (both hardwa Mais

$5000 USD in 45 dias
(2 Comentários)
3.5