FPGA designer using VHDL and/or Verilog for Xilinx and/or Altera FPGA(s)

$30-250 USD

Fechado

Publicado

há quase 6 anos

$30-250 USD

Pago na entrega

Design a 3-phase 500Hz FPGA based generator driving a quad-channel DAC (only 3 channels needed) such as the LTC 2624. The overall idea is that; following <RESET> a table of values representing a sine wave shall be stored internally and scan sequentially by the three output stages in a manner that each output is 120 degrees off-phase with each other as shown in the attached image. No other work is needed at this point. I will provide a Xilinx Spartan III demo board made by Digilent ([login to view URL]), if necessary and have it shipped to the developer. The developer is welcome to keep the board.

Electronics

ID do Projeto: 16955435

Sobre o projeto

7 propostas

Projeto remoto

Ativo há 6 anos

Quer ganhar algum dinheiro?

Endereço de e-mail

Benefícios de ofertar no Freelancer

Defina seu orçamento e seu prazo

Seja pago pelo seu trabalho

Descreva sua proposta

É grátis para se inscrever e fazer ofertas em trabalhos

7 freelancers estão ofertando em média $93 USD for esse trabalho

@ahmedmohamed85

Dear sir I already have the same board, u dont have to buy it and send it to me. have more than 10 years experience in digital design using FPGA, i can make this design and assist u to run it , please check my profile, also please message me so that we can discuss. Best regards

$100 USD em 3 dias

4,9

(240 avaliações)

7,5

@sajjadahmed19

Hi. I will do this job for you

$150 USD em 5 dias

4,8

(44 avaliações)

5,5

@kulwantsingh16

A proposal has not yet been provided

$80 USD em 3 dias

4,9

(4 avaliações)

2,6

@Engineerzeeshan

Hey i can design in both xilinx for spartan kits and Quartus for Altera FPGA, through i am fresh i dont havw reviews... But i can gauretee of perfection in my work..

$66 USD em 2 dias

0,0

(0 avaliações)

0,0

@thisisobul

I have 5 years of experience in vhdl including communication protocols like uart, ethernet, BIS and I am perfectly capable of completing your job.

$111 USD em 20 dias

0,0

(0 avaliações)

0,0

@bharadwajakarsh

I am an Electronics and Communication Engineer with a keen interest in Digital Design. I have done several projects on Verilog and VHDL. I feel I will be fit for this project since I have already worked on ADCs using FPGA before. I can share my Resume for reference if required.

$66 USD em 10 dias

0,0

(0 avaliações)

0,0

@LiaqatHumza

I have thoroughly read your project and fully understands your requirements. I am an Electronics Engineer with vast experience in Xilinx Spartan III. I have made many projects on Xilinx Spartan III and you donot need to send the board. I am ready to work on this project and waiting for your reply to futher discuss the project. Thanks.

$80 USD em 3 dias