Concluído

Project for analog engineer designing voltage boost electronic circuit

Requirement and spec for boost circuit.

Introduction:

As part of a larger project, we need to design a boost circuit to be integrated into our bigger project.

Requirements and spec:

Inputs:

* Power - Voltage 13 to 6 VDC supply for a boost power input.

* Circuitry power 3.3 VDC.

* Pre boost enable.

* Boost enable

* GND.

Output

* 15-20 VDC (charge 4700 uF capacitor) adjustable.

* Sense on capacitor voltage.

* Max input current: 25 mA (optimum).

* Max power consumed per boost ~ 200 micro Ah/boost.

* Boost charge time up to 12 sec.

BOM price must be below 3 USD preferably up to 1.5 USD for 1000 (components only). The component should be from well-known manufacturers.

Mode of operation:

Step one: Pre Boost through a switch (transistor) & resistor V_Bat is loaded to the capacitor until V_CAP=V_Bat-(dv_transistor+dv_diode(if needed)=?). Once pre Boost ended Boost starts until V_CAP setpoint 15-20 VDC.

Habilidades: Eletrônica, Microcontrolador, Design de Circuito , Electronic Design, Analog Electronics

Sobre o Cliente:
( 2 comentários ) Halutz, Israel

ID do Projeto: #24568155

Concedido a:

(1 Comentário)
2.7

8 freelancers estão ofertando em média $126 nesse trabalho

intellisenseIN

Hello, My name is Jaspreet & I'm part of larger embedded hardware and firmware development team. I just have gone through with your requirements very carefully. We can surely design a "voltage boost electronic circuit Mais

$180 USD in 10 dias
(5 Comentários)
4.4
etalhak

Hello, I am an electronics and telecommunication engineer. I can help you with your project, I have designed many circuits like this for my embedded system projects and led lighting system projects. So designing one of Mais

$110 USD in 3 dias
(3 Comentários)
2.5
arslan469

I know about it very well. I can garantee u one thing that i will done your work perfectly and thats my favorite

$40 USD in 3 dias
(0 Comentários)
0.0
nesflc

Hello, I have experience with DC/DC buck and boost converters and can help you with schematic/PCB design. What is purpose of preboost? Do you need two stage conversion? Regards, Milan

$140 USD in 7 dias
(0 Comentários)
0.0
kushalnandanwar

HI, I have worked with many DC to DC and buck and boost, I can make this circuit for you and if you want I can do manufacturing also for you want for testing purpose.

$140 USD in 7 dias
(0 Comentários)
0.0
qammarabbas313

Dear Client, I am an Electronics Engineer. Your project caught my eye earlier today. I strongly feel that the expertise required for the successful accomplishment of the project closely matches to my skill set as ment Mais

$120 USD in 7 dias
(0 Comentários)
0.0
Anishchenko

Welcome. Tell me what power you are interested in?

$55 USD in 3 dias
(0 Comentários)
0.0