Raspberry Pi Air Conditioner Automation -- 2
£10-20 GBP
Pago na entrega
Hello,
I am working on automating my air conditioner by reading the signals from the Remote, which i would like to then send out later to turn the AC on and off.
I have the following setup:
- Raspberry Pi 4B
- Breadboard
- VS1838B Infrared receiver
- 5mm 940nm IR infrared Emission
(along with other require items)
- hitachi remote rar-3n5-1
AC is:
The problem is i am not getting any readings on the ir receiver device.
I would like to do the following:
- Read Remote signals
- Check room temperature using sensor (this sensor is working)
- Send on & off signal based on temperature
I can provide more info on chat
Thank you!
ID do Projeto: #34832234
Sobre o projeto
Concedido a:
Hello. I am Prabhath an electronics engineer. First, let me describe a very similar project I did. The product is a TCP to IR hub, through which I can control any IR remote controller supported devices via phone. Usi Mais
4 freelancers estão ofertando em média £59 nesse trabalho
Hi There, I am professional electronics engineer and embedded system expert with experience of working on Raspberry pi. I seen the attached image, i think connection on the breadboard might be an issue. Just share you Mais
Hi. you want to get signal using IR receiver right? . I have experience using ir projects so i can help. more i have the hardware(ir receiver + raspberrypi ) so i can test myself as well Looking forward to your respons Mais
