Encerrado

MCU Breakboard design in Altium

I need somebody that can work over an existent Altium DXP (or Altium Designer Winter 09) schematic for the Atmel AVR32 MCU (AT32UC3B0256 TQFP64). Basically the schematic is done, but may need some modifications. The main workd is doing the double layer PCB. I will provide technical details about PCB design and an aproximate size for the board. the board needs basically the following features: * A Header connector (2Pins) for Power supply ([url removed, login to view] regulated externally) * The decoupling capacitors and all the internal power supply pins connected properly for a single [url removed, login to view] Supply * Reset and Clock circuit (12MHz Crystal) * A 4pin header connector for the USB (Device ONLY) port, with the required resistors. * Any other required component in order to program / run a program on the MCU. * PCB board needs for holes in each corner for mounting to future boards. * The Rest of the IO Pins must have connections to Header connectors. (this is not done on the schematic yet, and will be discuss with the coder) Reference Board Size: 11cm x [url removed, login to view] ONLY THE MCU IS SMD, THE REST OF THE COMPONENTS ARE NOT SMD.

## Deliverables

1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done.

2) Deliverables must be in ready-to-run condition, as follows? (depending on the nature? of the deliverables):

a)? For web sites or? other server-side deliverables intended to only ever exist in one place in the Buyer's environment--Deliverables must be installed by the Seller in ready-to-run condition in the Buyer's environment.

b) For all others including desktop software or software the buyer intends to distribute: A software? installation package that will install the software in ready-to-run condition on the platform(s) specified in this bid request.

3) All deliverables will be considered "work made for hire" under U.S. Copyright law. Buyer will receive exclusive and complete copyrights to all work purchased. (No GPL, GNU, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site per the coder's Seller Legal Agreement).

## Platform

ATMEL AVR32

Habilidades: Vale Tudo, Eletrônica, Engenharia

Ver mais: web design the complete reference, web design complete reference, web circuit design, software component design, power program in c, pcb web designer, pcb circuit board design, io web designer, hire technical designer, hire pcb designer, hire electronics, hire connections, future electronics, design pcb need, designer electronics, design boards, corner design, component board, clock design, circuit designer, atmel web, web board design, smd pcb, schematic design, regulated power

Acerca do Empregador:
( 13 comentários ) Quilmes, Argentina

ID do Projeto: #3056771

6 freelancers estão ofertando em média $59 para este trabalho

venellinus

See private message.

$59.5 USD in 14 dias
(26 Comentários)
4.8
makjee

See private message.

$63.75 USD in 14 dias
(15 Comentários)
4.1
sands1

See private message.

$42.5 USD in 14 dias
(3 Comentários)
4.0
Retep

See private message.

$63.75 USD in 14 dias
(1 Comentário)
3.3
zozo969

See private message.

$59.5 USD in 14 dias
(1 Comentário)
1.3
mamunruetsl

See private message.

$63.75 USD in 14 dias
(0 Comentários)
0.0