Em Andamento

Getting OpenWrt configured as a wireless access point

I'm trying to set up an OpenWrt installation to act as a wireless access point. My target system is RDC 321x / Bifferboard. All I want for full payment is the steps I need to take in order to get Openwrt to act as a wireless access point with DHCP, connecting to the LAN connection. If I need a USB dongle with a different chipset then part of the solution will be to find a site where such a dongle can be purchased.

## Deliverables

I've tried USB wireless dongles with chipsets zd1211rw, rtl8187 and rt2800-usb using the defaults from wifi detect but whilst the wireless network appears I can never ping the board's LAN IP address when connected. I'm using KAMIKAZE (bleeding edge, r24851). Here's my current wireless config with the rt2800-usb dongle attached: config wifi-device radio0 option type mac80211 option channel 11 option macaddr 00:xx:xx:xx:xx option hwmode 11ng option htmode HT20 list ht_capab GF list ht_capab SHORT-GI-20 list ht_capab SHORT-GI-40 list ht_capab RX-STBC1 # REMOVE THIS LINE TO ENABLE WIFI: option disabled 0 config wifi-iface option device radio0 option network lan option mode ap option ssid OpenWrt option encryption none

Habilidades: Software Integrado, Linux

Ver mais: openwrt access point, openwrt wireless access point, openwrt access point mode, openwrt rtl8187 usb mode, want wireless network, get wireless, part channel, wireless, ssid, rx, linux device, gf, embedded s, dhcp, lan access, software usb dongle, detect connection, embedded linux openwrt, dongle remove, wireless access system, wireless full, openwrt linux, dongle enable, wifi connection linux, detect usb device connected

Acerca do Empregador:
( 10 comentários ) United Kingdom

ID do Projeto: #3054183

Premiar a:

fifteenhex

See private message.

$21.25 USD em 2 dias
(23 Avaliações)
5.4