The attached file illustrates better. You are to write a 8085 program on the 8085 Primer Trainer using the input DIPs switches (port 12ff), output LEDs (portllH), Keypad (service 16 routines), 7-Segment LEDs (service 1IB). Write a simulation program for indicated system and then run the program using a system of switches and [url removed, login to view] description of the operation follows: When a STARTbutton is pushed, a SOLENOID A is energized and liquid enters a mixing tank. A FLOAT switch FS1 detects the upper limit of fluid allowed in the tank, and another FLOAT switch FS2 detects the lower limit. As the tank begins to fill FS2 closes. When the tank is ff11,FSI opens, shutting off SOLENOID A and starting a mixing MOTOJL The mixer MOTOR runs for 30 seconds and shuts off. As the mixer MOTOR is being shut off, SOLENOID B is energized to drain out the tank contents. When the contents have been drained, FS2 opens and shuts off SOLENOID B. At this point, the system remains idle until a new cycle is initiated. Enter the program, and verify correct operation. Some flexiblity is allowed, need it just close to method listed.
1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done.
2) Installation package that will install the software (in ready-to-run condition) on the platform(s) specified in this bid request.
3) Exclusive and complete copyrights to all work purchased. (No GPL, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site).
4) Need the Text file that will assemble and run.