Em Andamento

I2c PLL control ATMEL

This is for a different project than the other I have listed on this site

Essentially I need to control a PLL in a very basic fashion. the chip I have chosen for this project is the ATTINY12L by atmel

output is I2C to control the PLL. input to the TINY is 2 tactile switches for up and down . it is to roll over the the start if up passes upper limit set in software and the reverse for down [url removed, login to view] for [url removed, login to view] steps over a 30 mhz range. very basic and very simple. All frequency limits, scanning speed and last frequency used are to be stored in the eeprom location of the TINY. The software is to write its last frequency load to eeprom so at power loss, it knows where it was and can resume from last setpoint

PLL datasheet is enclosed

Make me an offer.

Thanks very much

## Deliverables

1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done.

All variables located in e2

## Platform

ATMEL instruction set

Habilidades: Software Integrado, Engenharia, MySQL, PHP, Arquitetura de software, Teste de Software

Ver mais: tactile, software engineering resume, resume engineering, engineering resume, reverse engineering project, speed control, i2c, atmel, setpoint, atmel tiny, enclosed source, source datasheet, chip code, simple program instruction, reverse loss, program chip, control range, write fashion site, range control, power control, chip control, atmel project, reverse engineering software program, php form switches, program eeprom

Acerca do Empregador:
( 16 comentários ) Canada

ID do Projeto: #3000953

Premiar a:

curvexvw

See private message.

$63.75 USD em 15 dias
(17 Avaliações)
4.6

3 freelancers estão ofertando em média $58 para este trabalho

solidworksvw

See private message.

$68 USD in 15 dias
(17 Comentários)
4.5
egainvw

See private message.

$42.5 USD in 15 dias
(1 Comentário)
0.0