I need a mechanical / structural engineer for the following tasks:
1. Model the pump and skid attached in 3D (using an industrial 3D software). Pump type is a pneumatic double diaphragm pump for chemical dosing applications (pump skid dimensions to be assumed by the engineer, would be corrected during review). Member sizes to also be assumed.
2. Model the dosing tank to contain:
i. A 2" RF 150# blinded drain nozzle (located at the bottom of the tank)
ii. A 2" RF 150# inlet nozzle (located at the top of the tank)
iii. A 12" RF 150# manhole (located at the top of the tank)
iv. A 3/4" RF 150# outlet nozzle (located at the bottom of the tank)
Tank plate should be 1/2" thick and dimensions should be 1.5m x 1.5m X 1.5m
A primitive model could be used to represent the tubing for now.
Note; This model will also be leveraged to develop 2D fabrication drawings for the skid structural framing and tank.
Dr. Wisdom Enang