I need (3) of the 3-D modeling/rendering drawings revised. These are (3) drawings you completed for me previously. -- 3
$10-30 USD
Pago na entrega
Die Cast Knuckle; the end of the part that inserts into the handle needs to be flattened out and the edges of the flat need a radius (so it will slide into the handle easily).
Rail Clamp; The rail clamp was a basic rectangle shape that slid over the top of the handle. A screw through the handle holds the Rail Clamp onto a rail. The Rail Clamp needs to be in the shape of a "T". The new lower protrusion of the "T" slides into a new cut-out on the handle, which will help the screw hold the assembly to the rail. The Rail clamp has been widened to 1.363.
The top part of the handle had a 1.250 dimension, which left small nubs on top. This dimension has been changed to 1.363, eliminating the nubs. The area where the Rail Clamp protrudes into the handle needs to be added, also.
ID do Projeto: #5721553
Sobre o projeto
Concedido a:
3 freelancers estão ofertando em média $59 nesse trabalho
please check my porfolio Sir 200% we can do your job we have a good team special in this work. massage me fast so that we can start your work..