We need to edit 25 3D Files.
1. Engrave the bottom of the base with the name or nickname of the vehicle. I.e. Puma, Sherman, Wolverine, Jeep, Greyhound etc… As large as letters as possible.
2. Assemble. In a few cases the vehicle will need to be assembled if the treads or wheels are separate. (should only be 3 or 4 like this).
3. Resize. Some slight resizing on specified units. (Approximately 10) The Vehicle Size spreadsheet identifies which ones are a little bigger than the source file (green) and which ones should be a little smaller than the source files (red). Note that measurements are all with Guns attached and in forward position. But we need the turreted guns in separate files afterwards.
Then the bigger redesign jobs are::
Reinforce Turret guns and other thin pieces. Fill in empty spaces and undercuts where possible.
Thicken guns for added strength. Where possible reinforce the area where the gun enters the turret. (making the gun curve wider where it enters the turret).
The trick is we do not want to alter the visual look too much. Also we do not have a lot of time for this so this has to be a quick going over.
Firefly (Birtish) rockets - fill in empty spaces
Churchill AVRE turret (British). Make 2x larger and point at upwards angle. Simplify design fill in gaps and smaller pieces.
Sexton (British). Angle gun upwards (45 degree like the Churchill). Remove any under-cuts from inside the carriage. (gaps underneath the gun etc..)
SturmTiger - remove crane and thin pieces
Calliope (USA)- make rocket section one solid piece. Fill in empty spaces.
Redesign attachment system slots to be MUCH bigger. (right now they are tiny.) Or create a new system that snaps on.
Priest (USA). Attach and angle gun at 45 degrees. Fill in under the gun inside the carriage so there is no under cut.
Ostwind (German) - Cover top of turret area in camo netting / blanket. Have it drape down the sides. So the whole top is one solid piece :) (BIG JOB)
All Files and Vehicle Size Spreadsheet HERE:
[login to view URL]
31 freelancers estão ofertando em média $565 para esse trabalho
Hi, i am very interested in your project & when you need it any deadline?? check Portfolio work:- [login to view URL] https://www.freelancer.in/u/razer5 thank you
I'm an artist and designer specialized in 3D modeling and with experience preparing files for 3D printing. Please check my portfolio for references and contact me to discuss details.
⭐Hi, I am interested to make the changes in all 35 files. Please write me in chatbox to discuss ahead. I've 10 years of extensive knowledge in SolidWorks, Product Design. Best Regards Suman Singh
Hi i am a 3d generalist with lots of experience with 3d printing and miniatures, i would happily assist you in these ww2 miniatures. Kindly msg me for further assistance
Hello I saw your description carefully. I can do your task. I am 3D expert. I have full experiences more than 5 years. If I have a chance to help you, I will work honest and ASAP. Best your regards.