...window • Two display areas that display the status of the elevator, i.e. which floor the elevator currently stays, one is of each floor • A log button Task 2: To create a control program that processes the events published by the GUI. That is, • When any request button is pressed, o the elevator appears in the corresponding floor o then the display
Pic micro controller to measure 3 phase voltage and current measurement & control the relays based on current readings
I am using PIC32MX250F128B for my project. I have written a code where I am collecting data from a vibration sensor and sending them to the sram (23LC1024) and then displaying them through the serial monitor as they are sampled. I am using timer3 to control the ADC and set my sampling frequency. The main problem in that is I am not able to store the
...should be stored on the microcontroller. When close to each other 2 guests' microcontrollers with same input (eg letter A) should be able to recognize each other and to give a signal like Led is on, a buzz or a signal. The guests should be able to adjust on the website the range for discovery in the network. On the microcontroller should be a button for
chipKIT Max32 Digilent Microcontroller Programming with the following/not limited sensors 1. Accelerometer 2. Temperature 3. RPM [login to view URL] shield [login to view URL] shield [login to view URL] Shield 7. etc
I need a Arduino, Electronics, Microcontroller, PCB Layout expert for my current project. If you have knowledge please bid. Details will be shared in message with the selected freelancers.