GSM GPS Tracker with CAN Interface
$1500-3000 USD
Pago na entrega
We need for a project as soon as possible a full functioning protoyp of a device with reads data from the GPS channal and the CAN open interface. THis data are then sent to a server (FTP, IP-Socket) via the GSM Channel. The GSM channel should work in Eurpoe (quad Band).
If no GSM is available the data are stored on a SD card inside the system. (max 2GB)
Needs:
- Protoype with SW
- SOurce Code of SW
- Layout Files (Eagle or any other Standard)
- Board Form Factor: as small as possible without housing.
- Antennas: GPS on Board and GSM also on Board or socket (SMA or smaller)
- at least one free I2C, SPI or RS232 CHannel on the board. Testpoints
-
Chip used:
- ST ARM Cortex M3 / STM32F103RCT: 256kB Flash, 48kB SRAM
- uBlox GSM and GPS Modules
Additional Information:
- Realt TIme OS for the ARM wanted.
- Open Source Dev. Framework if possible
ID do Projeto: #1212778
Sobre o projeto
12 freelancers estão ofertando em média $2783 nesse trabalho
Hi, electronic engineer with over 15yr experience, i can help you. i will design a full working prototype as you expect. Please check PMB
Dear Sir, We have more 8 yrs of experience in Embedded systems, GSM, GPRS, GPS and embedded webservers. We can do it.
Hi , we have end to end product development experience and developed various products based on offline and online vehicle tracking with GPS,CAN and GSM?GPRS technologies. for offline storage we used SD card with FAT in Mais
