Write a driver for arduino for ROHM BU97950AFUV LCD Driver

From the provided datasheet write a 1/8 generic driver for a ROHM BU97950AFUV to setup for either 3.3v or 5v supply.A class library where a graphic is in memory array and can be displayed in a similar manor used to drive common Nokia 84x84 displays The BU97950AFUV is responding and accepting this sketch however It is not displaying and needs the configuration to be set correctly from the attached datasheet #include <Wire.h> #define LCD_I2C_ADDR 0x3E unsigned char lcd_pos; unsigned char lcd_char; unsigned char lcd_buffer[]={ 0x4C|0x80, // Mode set (1/3 bias, enabled, static display), more commands 0x60|0x80, // Select device 0, more commands 0x70|0x80, // No blinking, more commands 0x00, // Reset data pointer, last command 0xFF, // 8 characters follows, 2 bytes each 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF }; void setup() { [login to view URL] (9600); [login to view URL](); [login to view URL] (LCD_I2C_ADDR); for (unsigned char j = 0; j < 40; j++) { [login to view URL](lcd_buffer[j]); } [login to view URL] (); lcd_pos=4; } // end of setup void loop() { lcd_char=1; for (unsigned char i = 0; i < 8; i++) { lcd_buffer[lcd_pos] =lcd_char; [login to view URL] (LCD_I2C_ADDR); for (unsigned char j = 0; j < 40; j++) { [login to view URL](lcd_buffer[j]); } [login to view URL] (); lcd_char=lcd_char*2; delay(50); } /* USER CODE BEGIN 3 */ lcd_buffer[lcd_pos] =0; lcd_pos++; if (lcd_pos==37)lcd_pos=4; }