I need source code of embedded software

$30-250 USD

Fechado

Publicado

há mais de 5 anos

$30-250 USD

Pago na entrega

I need reverse engineering support. I have an electronic card module and with software. Most of software parts are open source already but small parts are not. Software was designed on IAR 6.7 and module has STM32 and ARM Can you provide to open source part and edit/clean/revise codes and be ready to compiler the software for using?

Embedded Software

ID do Projeto: 18706369

Sobre o projeto

5 propostas

Projeto remoto

Ativo há 5 anos

Quer ganhar algum dinheiro?

Endereço de e-mail

Benefícios de ofertar no Freelancer

Defina seu orçamento e seu prazo

Seja pago pelo seu trabalho

Descreva sua proposta

É grátis para se inscrever e fazer ofertas em trabalhos

5 freelancers estão ofertando em média $173 USD for esse trabalho

@fermatliu

Hello I am expert for C/asm programming. I do reverse before. Can you give more information about ur project？ Time & Fee should negotiate later, do U agree

$30 USD em 30 dias

0,0

(0 avaliações)

0,0

@SimonZhang0212

I have ten years experience in embedded systems, good at using keil or IAR studio,. I think I can help you.

$277 USD em 8 dias

0,0

(0 avaliações)

0,0

@hayat38402

I'm an electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM) and some analog I/O. I design complete board: power section, MCU section, peripheral section, I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone ) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design.

$250 USD em 3 dias