power systems project in simulink

Hello, I need your help with simulink. My project is about protecting a series compensator called SSSc (static synchoronus compensator) When a fault happens in one side of the network using thyristor crowbars to absorb that high fault current. The network is a medium voltage 11 kv that consists of only 2 busbars. The simulink model is ready I just need you to do a simple task for me in the simulink model i attached and they are: make the following procedure to the network: at t=1 steady state at t=1 the fault happens at t=1.01 turn on the tyristors at t=1.1 cut off the SSSC by tripping the circuit breakers at t=1.12 thyristors are switched off I have already added the fault, and did everyhting else in the network. All you need to do is the above procedure. That's all you need to do and it won't take much of your time. I will attach the simulink model and parameters and a picture of the distribution network so you can visualise it better along with some relevant information. I have attached a dissertation that is similar to my project, check chapter 5 only.