Atmel AVR - C programming of a 1-wire interface

Hi, I hope you are doing well. I have experience with 1-wire interface with similar set of devices with AVR MCU. I would like to discuss the project in detail. Looking Forward, Khawaja

Hello, have a great day. My name is Shahbaz. I am running a setup for Electronic circuit design and prototyping setup. We will deliver you fully tested design and firmware. We will clone Arduino and the firmware will be based on arduino. There will be single chip ATmega328 or any other compatible microcontroller. Please feel free to contact. Best Regards, Shahbaz.

A proposal has not yet been provided

A proposal has not yet been provided

I already worked with this one. Take a look over completed project : https://www.freelancer.com/projects/C-Programming/wire-channel-adressable-switch-wire/ .Cheers, Gabriel.

Will be n C in any AVR platform read(),write() function called with arguments. Also support for implementation varification

I used various 1-wire devices with Atmel AVR Atmega. You want to use a serial-1wire converter. Many times I did it by software, microcontroller communicates directly to 1-wire device(s) using a common I/O pin.

A proposal has not yet been provided

Hello, I am an embedded software engineer and I'm looking forward to know more about your project so I start working on it as soon as possible.

Hello! I have good experience in this sphere (AVR microcontrollers)!I work in Atmel Studio (or AVR Studio ) for programming AVR microcontrollers.

Hello, I can provide you with a quick solution for this not working on hours but for a full price depending on what you want to do. Also I can help you with the project moving forward if you need future modifications. Best Regards, Brayan M.

Hi ! We have experience programming Atmel AVR , because early we used this microcontrollers in our developing device. Can we discuss our project ?

i have proficient knowledge of c programming currently am working on register machine processing so hope i could do this one too

i have worked on uart before, i am looking forward to hear the details, i have worked on PIC18F4550, familier with rs232. As a i new freelancer, and i am unemployed i can give my efforts without any flaws.

- 7+ years of experience in real-time and non real-time firmware development - Experience developing low level microcontroller firmware to high-end SoC based application development - BSP Development - Drivers, Middle ware & Application - OS: Linux, OpenWRT - OpenWRT based CPE router development on TI based reference board - Complex multi-threaded linux application development - Worked on Qualcomm's 802.11 based wireless module - In past, developed TCP dump application to sniff and dump network packets

A proposal has not yet been provided

DS2480B is not obviously requied. It's possible to provide 1-wire with just AVR. See my portfolio "serial port program" - it's a project with 4 DS18B20 termo sensors (they use 1-wire to communicate). Possibly I would be able to find the code from that project, it would save a lot of time. (I used AVR in that project)

I have years of experience with AVR MCUs, I can do this library in C without too much problem. If you would like I can get hold of a 1-wire and do validation.

Dear, We are skilled programmers and designers of hardware with 15 years of experience. We have a well-equipped laboratory, expert team from Faculty of Electrical Engineering, which consists of professors and graduate engineers. We are ready to realize a Project from concept to prototype. We hope to gain your trust. Have a nice day. Kindest regards.

A proposal has not yet been provided